1-1/4" - 2" Tapered Cone Buff, 100% Layered Cotton, 1/4" Drill Arbor

Tackle polishing hard-to-reach contours and tight radii with our tapered cone buff.

Whether you’re polishing exhaust headers, wheel hubs or decorative metal trim, this tapered cone buff gives you access and performance where flat buffs won’t.

Made from 100% layered fine cotton, this medium-density buff performs significantly better than standard felt bobs.

Specs:

• 100% fine cotton medium density buff for use with fine and pre-polishing compounds

• Medium-density cotton design provides a balanced combination of firmness and flexibility for light cutting and intermediate polishing stages and delivers greater cutting pressure and faster material removal than loose-sewn buffs while still conforming to curved or contoured surfaces.

• Tapered 1-1/4″ tip - 2″ base diameter can be used on flat surfaces, reaches deep crevices and curved profiles

• 1/4″ arbor fits standard drills

• For best results, use moderate drill speeds around 600 - 1,200 RPM. Do not exceed 1,500 RPM.

Ideal for:

Autobody and detailing shops, metal finishers, marine restorers working on aluminum, stainless steel, cast components or chromed trim.

Usage & Care Tip:

Don’t mix compounds on the same buff. Dedicate a buff to each compound.

This buff works best with brown tripoli, green and white polishing compounds for light cutting and intermediate polishing stages. Also compatible with white, red and blue fine polishing compounds for finsihing. Not intended for aggressive / coarse polishing abrasives.

Operate your drill or rotary at approximately 600 - 1,200 RPM for optimal finish and buff life. Do not exceed 1,500 RPM, as higher speeds may generate excessive heat, shorten buff life and risk of damage to the workpiece.

Clean the buff regularly to remove embedded compound and debris.

Replace the buff when you observe the tapered edges becoming visibly compressed, heavy discoloration, noticeably longer polishing times, or increased heat transfer to the workpiece.